User`s manual

6 - 1

MELSEC-Q

6. PROJECT CREATION

A project is a collection of parameters, positioning data and block start data.

<SW

D5C-QD75P-E project makeup>

Project

Parameters (Axis #1 to #4)

There are basic parameters 1, basic parameters 2, extended parameters 1,

extended parameters 2, OPR basic parameters and OPR extended parameters.

Positioning data (Axis #1 to #4)

Data used to set the control data such as positioning control method and addresses.

Data No. 1 to 600 can be set for each axis.

Block start data (Axis #1 to #4)

Data used to attach a condition to a positioning control start and set the repeat count.

Note: Equivalent to the start block data of the AD75 positioning module.

• When executing "New Project" or "Save as Project", you cannot set a space and

period in the project name to be specified. Further, you cannot set the following

characters and symbols.

/ , : ; * " < > | \\ COM LPT AUX CON PRN NUL CLOCK$

• You cannot set the following characters and symbols in a project path.

/ , : ; * " < > | \\ COM LPT AUX CON PRN NUL CLOCK$