User`s manual

6 - 11
MELSEC-Q
6. PROJECT CREATION
6.6.2 Reading the CSV format file
PURPOSE
SW D5C-QD75P-E allows CSV format files created with spreadsheet software,
etc. be read as positioning data (axis #1 to #4). (Parameters and block start data
cannot be read.)
The creating method and reading operation of CSV format data are described
below.
• If all items that make up positioning data have not been entered, CSV format data
cannot be read, resulting in an error.
• Since CSV format data is read axis-by-axis, create CSV format data noting which
axis (#1/#2/#3/#4) data is being created.
(1) CSV format data creating method
The following sheet indicates the items and values of CSV format data set on a
column basis.
<Example of data set to spreadsheet software>
2) 3) 4) 5) 6) 7) 8) 9) 10) 11) 1)
<Data set to the above spreadsheet software was read with SW D5C-QD75P-E>
Number Setting Remarks
1) Set the positioning control pattern in column 1 from left. Set any value from 0 to 2.
2) Set the operation method in column 2 from left. Set it with 1 to 9 and A to Z.
3) Set the interpolation axis for two-axis interpolation control in column 3 from left.
4) Set the host axis for single-axis or three-/four-axis interpolation control.
5) Set the accel time No. in column 4 from left. Set it from 0 to 3.
6) Set the decel time No. in column 5 from left. Set it from 0 to 3.
7) Set the address in column 6 from left.
8) Set the circular positioning address in column 7 from left.
9) Set the command speed in column 8 from left.
10) Set the dwell time in column 9 from left.
11) Set the M code in column 10 from left.
Refer to Section 8.2
for details of data
corresponding to
alphanumeric
values to be set.