Instruction manual

MELSERVO J2-Super V
Special safety instructions for the devices
b
CAUTION:
●
During the installation of servo systems beware of the heat that builds up during
operation. Make sure that there is adequate clearance between the individual
modules and enough ventilation to allow the heat to be dissipated.
● Never install servo amplifiers or servo motors or the optional brake unit close to
easily flammable materials.
● When using a servo system always observe strict compliance with electrical
characteristics and physical dimensions.
● In the event of a defect arising in the servo amplifier, servo motor or optional brake
resistor immediately switch the power off to the servo drive, as otherwise it may
lead to overheating and self-ignition of the devices.