Specifications

10– 12
10. SPECIFICATIONS
(4) HC-SF series
For General Industrial Machines
(HC-SF G1(H))
As in 1) in this section
As in 1) in this section
As in 1) in this section
As in 2) in this section
Opposite direction to the servo motor shaft
40 minutes to 2°
at reduction gear output shaft
4 times or less
2000[r/min]
Available
Flange mounting
In any directions
Grease lubrication (Already packed)
LDR101BJ of American Oil Center
Research make
Same direction as the servo motor shaft
3 minutes or less at reduction gear output
shaft
5 times or less
0.5 to 1.5kW:3000[r/min]
2 to 3.5kW:2500[r/min]
For Precision Applications
(HC-SF G2)
Mounting method
Mounting direction
Output shaft rotating direction
With electromagnetic brake
Backlash
Permissible load inertia moment ratio
(when converting into the servo motor shaft)
Permissible speed
(at servo motor shaft)
Reduction Gear Series
Recommended
grease
Lubrication
1) Lubrication of reduction gears for general industrial machines
Oil lubrication cannot be used in applications where the servo motor will move. Specify grease
lubrication.
For grease lubrication, the reduction gear is already grease-packed.
For oil lubrication, pack the reduction gear with oil on the customer side.
4105
4115
4135
4165
4175
Grease
Grease
Note: Grease-lubricated type is also available.
Shaft in Any Direction
CNHM
(leg type)
Grease
Grease
CNVM
(flange type)
(Note) Oil
(Note) Oil
Oil
Shaft Horizontal
CHHM
(leg type)
(Note) Oil
(Note) Oil
Oil
CHVM
(flange type)
(Note) Oil
(Note) Oil
Oil
Shaft Downward
CVHM
(leg type)
(Note) Oil
(Note) Oil
Oil
CVVM
(flange type)
Grease
Grease
Shaft Upward
CWHM
(leg type)
Grease
Grease
CWVM
(flange type)
Mounting
Direction
Reduction gear
model
Reduction gear
frame No.
The reduction gear frame numbers are as follows:
4105 4115
4165
1/6 1/11 1/17 1/29 1/35 1/43 1/59
4115 4135 4165
4115
4115
4135
4135
4165
4165
4175
HC-SF52(B)G1 (H)
HC-SF102(B)G1 (H)
HC-SF152(B)G1 (H)
HC-SF202(B)G1 (H)
HC-SF352(B)G1 (H)
Servo Motor
Reduction Ratio