Specifications

2. OPERATION

2– 25

This mode cannot be used for the absolute position detection system.

Set parameter No. 1 to select the incremental positioning system.

MEMORANDUM

(3) Test operation mode

1) Jog feed

Jog feed can be performed without pulse train input from acommand unit or the like.

b. Starting method

Perform the following operation to rotate the servo motor at 200r/min.At this time, the

acceleration/deceleration time constant is 1s. Whenperforming jog feed, connect EMG-

SG and VDD-COM (when internal power supply is used).

a. Mode change

Call the display screen shown after power-on.

DOWN

Rotation

Direction

CCW

Operation

Press

To stop, release the corresponding button.

c. Status display

Press

MODE

to display the servo status during test operation. The display data is the

same as in the status display in Section 2-3-2.

d. Termination of jog feed

To terminate the jog feed, switch power off once or call the screen using

MODE

and press

SET

for more than 2s.

CAUTION

Press UP three times.

When this screen appears, jog feed can be performed.

• • •••••

Flickers in the test operation mode.

Press MODE once.

Press SET for more than 2 seconds.

1. The test operation mode is designed to confirm servo operation and

not to confirm machine operation. In this mode, do not use the servo

motor with the machine. Always use the servo motor alone.

2. If any operational fault has occurred, stop operation using the emer-

gency stop (EMG) signal.