Specifications

2. OPERATION
2– 52
Adjustment 2
Adjustment 3
Step Operation Description
Set 0101 in parameter No. 2.
Set the machine's load inertia moment to servo
motor inertia moment in parameter No. 34.
(When it is unclear, set an approximate value.)
Set 2 in parameter No. 2.
In parameter No. 37, set a value about 100
smaller than the value set automatically in step 3.
Execute steps 2 to 4 of Adjustment 1.
When machine response does not occur any
more, confirm the operating status, and at the
same time, gradually increase the setting of
parameter No. 37 reduced in step 4.
To reduce the settling time, increase the
response level of parameter No. 2 sequentially
and execute steps 1 to 6.
Auto tuning is selected.
Response is set to low level.
When this parameter value is set, the following
parameter values are set automatically. Each value
provides an ideal, hunting-less gain for parameter
No. 34 if machine resonance does not occur.
• Parameter No. 6
• Parameter No. 35
• Parameter No. 36
• Parameter No. 37
• Parameter No. 38
Auto tuning is made invalid to enable manual
setting of parameters No. 6 • 35 to 38.
The optimum value is achieved just before
vibration begins to increase.
Set a value which is about 50 to 100 smaller than
the set value at which gear noise and/or vibration
begins to be generated by machine resonance.
2
3
4
5
6
7
1
Operation DescriptionStep
Set 0101 in parameter No. 2.
Set the machine's load inertia moment to servo
motor inertia moment in parameter No. 34.
(When it is unclear, set an approximate value.)
Switch servo on and perform operation several
If vibration still persists, execute steps 2 and 3.
If vibration occurs due to machine resonance,
make adjustment in the
procedure of Adjustment 1 or 2.
Auto tuning is selected.
Response is set to low level.
When this parameter value is set, the following
parameter values are set automatically. Each
value provides an ideal, hunting-less gain for
parameter No. 34 if machine resonance does
not occur.
• Parameter No. 6
• Parameter No. 35
• Parameter No. 36
• Parameter No. 37
• Parameter No. 38
Auto tuning is performed.
1
2
3
4
5