Repair Manual

ALTERNATOR AND IGNITION SYSTEM
ENGINE OVERHAUL <4A9>
11B-10
REMOVAL SERVICE POINTS
<<A>> CRANKSHAFT PULLEY BOLT
REMOVAL
AK600409
AB
MB991883
<M/T>
AK600407
MD998781
Cylinder block
Drive plate
AB
<CVT>
1. Lock the drive plate or the flywheel with the
special tool Flywheel Stopper.
2. Remove the crankshaft bolt.
• Flywheel Stopper (MD998781)
• Flywheel Stopper (MB991883)
INSTALLATION SERVICE POINTS
>>A<< CRANKSHAFT PULLEY / WASHER
/ CRANKSHAFT PULLEY BOLT INSTAL
-
LATION
AK600410
AC
MB991883
<M/T>
AK600407
MD998781
Cylinder block
Drive plate
AB
<CVT>
1. Lock the drive plate or the flywheel with the
special tool Flywheel Stopper.
• Flywheel Stopper (MD998781)
•
AK305393
AB
Washer
Crankshaft pulley
Crankshaft
Crankshaft
bolt
Clean
Flywheel Stopper (MB991883)
2. Clean the threaded holes in the crankshaft.
3. Clean and degrease the crankshaft pulley.
NOTE: Degreasing is required to prevent any
remaining oil from compromising the friction coef
-
ficient of the pulley belt contact surface.
4. Install the crankshaft pulley.
5. Apply an appropriate minimum amount of engine
oil to the threaded portion as well as the flange
bottom of the crankshaft.
6. Clean the washer.
7. Tighten the crankshaft bolt to 190 N⋅m.
Main
Index
Group
TOC