Owner’s Manual
Theft-alarm system
Features and controls 5-41
5
The alarm can be deactivated in the following
ways.
By using the keyless entry system or the
F.A.S.T.-key operation to lock or unlock
the door.
Turn the ignition switch to the “ON” posi-
tion.
The system will be disarmed if the following
operation is performed.
The ignition switch is turned to the “ON”
position.
All doors are unlocked by the keyless
entry system or the F.A.S.T.-key opera-
tion.
Use the following procedure to test the sys-
tem:
1. Lower the driver’s window.
2. Arm the system as explained in “Armed
stage”.
3. Make sure that the theft-alarm indicator
comes on and flashes for approximately
20 seconds.
4. Wait a few seconds and then unlock the
driver’s side door by using the inside door
lock knob and open the door.
5. Check to be sure that the horn sounds
intermittently and the headlights blink on
and off when the door is opened.
6. Disarm the system by unlocking all doors
by the keyless entry system or the
F.A.S.T.-key operation.
NOTE
The alarm will continue to operate for 3 min-
utes. At the end of that period, the alarm will
automatically shut off to save battery power.
The system will then be rearmed until the
proper disarming step is taken.
The alarm will resume if unauthorized
actions are taken again, even if the alarm has
stopped.
While the alarm is operating, a warning is
displayed on the information screen in the
multi-information display.
Alarm deactivation
Disarmed stage
NOTE
If the UNLOCK button is pressed when all
doors are closed and no door is opened
within approximately 30 seconds, re-arming
will automatically occur.
The amount of time after unlocking until the
vehicle relocks automatically can be
adjusted. See an authorized Mitsubishi
Motors dealer for details.
Disarm...by the keyless entry system or
F.A.S.T.-key operation
Once the system has been disarmed, it can-
not be rearmed except by repeating the arm-
ing procedure.
Testing the theft-alarm system
NOTE
BK0210800US.book 41 ページ ２０１４年４月８日 火曜日 午前１１時２８分