Owner’s Manual
Tire pressure monitoring system
Features and controls 5-85
5
N00518900234
If the set speed driving is deactivated by the
condition described in “To deactivate” on
page 5-84, you can resume the previously set
speed by pressing the “ACC RES” switch (C)
while driving at a speed of about 25 mph (40
km/h) or higher.
Under either of the following conditions,
however, using the switch does not allow you
to resume the previously set speed. In these
situations, repeat the speed setting procedure:
The “ON OFF” switch is pressed.
The ignition switch is turned OFF.
“CRUISE” indicator light is turned OFF.
N00530201511
The tire pressure monitoring system uses tire
inflation pressure sensors (A) on the wheels
to monitor the tire inflation pressures. The
system only indicates when a tire is signifi-
cantly under-inflated.
CAUTION
When the set speed driving is deactivated
automatically in any situation other than
those listed above, there may be a system
malfunction.
Press the “ON OFF” switch to turn off the
cruise control and have your vehicle
inspected by an authorized Mitsubishi
Motors dealer or a repair facility of your
choice.
To resume the set speed
Tire pressure monitoring
system
WARNING
The spare wheel does not have a tire infla-
tion pressure sensor.
When the spare tire is used, the tire pres-
sure monitoring system will not work
properly.
See an authorized Mitsubishi Motors
dealer as soon as possible to replace or
repair the original tire.
NOTE
The tire pressure monitoring system is not a
substitute for regularly checking tire infla-
tion pressures.
Be sure to check the tire inflation pressures
as described in “Tires” on page 9-12.
Each of the grommets and washers where the
tire inflation pressure sensors are mounted
should be replaced with new ones when the
tire is replaced.
For details, contact your authorized Mitsubi-
shi Motors dealer.
Grommet
Washer
Tire inflation
pressure sensor
BK0210800US.book 85 ページ 2014年4月8日 火曜日 午前11時28分