Motors Automobile Parts User Manual

MANUAL TRANSMISSION (E-W) -

Input Shaft <F5M41>

22B-5-7

PWEE9508-A

Nov. 1995Mitsubishi Motors Corporation Added

SYNCHRONIZER RING

(1) Check to ensure that the clutch gear tooth surfaces are

not damaged and broken.

(2) Check to ensure that the cone inside diameter is not

damaged or worn and that the threads are not crushed.

(3) Press the synchronizer ring against the gear and check

clearance “A”. If “A” is less than the limit, replace.

Limit: 0.5 mm

SYNCHRONIZER SLEEVE AND HUB

(1) Check to ensure that when the synchronizer sleeve and

hub are combined and made to slide, they slide smoothly

without binding.

(2) Check to ensure that the front and rear ends of the sleeve

inside surface are not damaged.

SYNCHRONIZER SPRING

Check to ensure that the spring is not sagging, deformed

or broken.

SPEED GEARS

(1) Check to ensure that the helical and clutch gear tooth

surfaces are not damaged or worn.

(2) Check to ensure that the synchronizer cone surfaces are

not roughened, damaged or worn.

(3) Check to ensure that the gear inside diameter and front

and rear surfaces are not damaged and worn.

PWEE9508-G

Jun. 2000Mitsubishi Motors Corporation Revised

Synchronizer ring Gear