Motors Automobile Parts User Manual

MANUAL TRANSMISSION (E-W) -
Output Shaft <F5M41>
22B-7-5
PWEE9508-A
E
Nov. 1995Mitsubishi Motors Corporation Added
"
J
A
SNAP RING INSTALLATION
Select and install a snap ring so that the output shaft rear
bearing e n d play will have the standard value.
Standard value:
-0.01-0.09 mm
"
K
A
SYNCHRONIZER SPRING INSTALLATION
Install the synchronizer spring securely inthe illustrated position
of the outer synchronizer ring.
INSPECTION
OUTPUT SHAFT
Check the splines for damage and wear.
NEEDLE ROLLER BEARING
(1) Check to ensure that when the bearing sleeve and gear
are combined an d made to rotate, they rotate smoothly
without looseness and noise.
(2) Check to ensure that the cage is not deformed.
SYNCHRONIZER RING
(1) Check to ensure that the clutch gear tooth surfaces are
not damaged and broken.
(2) Check to ensure that the cone inside diameter is not
damaged or worn and that the threads are not crushed.
PWEE9508-F
E
July 1999Mitsubishi Motors Corporation Revised
Synchronizer
spring