Motors Automobile Parts User Manual

MANUAL TRANSMISSION (E-W) -
Output Shaft <F5M41>
22B-7-6
PWEE9508-A
E
Nov. 1995Mitsubishi Motors Corporation Added
(3) Press the synchronizer ring against the gear and check
clearance “A”. If “A” is less than the limit, replace.
Limit: 0.5 mm
OUTER SYNCHRONIZER RING / INNER
SYNCHRONIZER RING / SYNCHRONIZER CONE
(1) Check to ensure that the clutch gear tooth surfaces and
cone surfaces are not damaged and broken.
(2) Install the outer ring, inner ring and cone, press them
against the gear, and check clearance “A”. If “A” is less
than the limit, replace.
Limit: 0.5 mm
Caution
When the outer ring, inner ring or cone has to be
replaced, make sure that the outer ring, inner ring
and cone are replaced as a set.
SYNCHRONIZER SLEEVE AND HUB
(1) Check to ensure that when the synchronizer sleeve and
hub are combined and made to slide, they slide smoothly
without binding.
(2) Check to ensure that the front and rear ends of the sleeve
inside surface are not damaged.
SYNCHRONIZER SPRING
Check to ensure that the spring is not sagging, deformed
or broken.
A
Synchronizer ring Gear
A
Outer ring
Cone
Inner ring
Gear
PWEE9508-G
E
Jun. 2000Mitsubishi Motors Corporation Revised