Motors Automobile Parts User Manual

MANUAL TRANSMISSION (E-W) -
Center Differential <W5M42>
22B-16-2
A
B
"
TAPER ROLLER BEARING REMOVAL
Use the special tools to remove the taper roller bearing.
REASSEMBLY SERVICE POINTS
"
A
A
TAPER ROLLER BEARING INSTALLATION
Use the special tool to install the taper roller bearing.
"
B
A
TAPER ROLLER BEARING INSTALLATION
Use the special tools to install the taper roller bearing.
"
C
A
SPACER/SIDE GEAR/WASHER/PINION/PINION
HOLDER/PINION SHAFT/LOCK PIN/FRONT
OUTPUT SHAFT/SNAP RING/CENTER
DIFFERENTIAL FLANGE INSTALLATION
(1) Install t he side gear in the center differential case with
the spacer attached.
NOTE:
If a new side gear is to be installed, select a spacer with
medium thickness (0.93 - 1.00 mm).
(2) Fit the washer on the back of each pinion. Engage the
4 pinions simultaneously in the side gear.
Rotate the gears to place them in position, then install
the pinion shaft holder.
(3) Insert the pinion shafts.
(4) Install the lock pins in the illustrated direction.
PWEE9508-E
E
Jun. 1998Mitsubishi Motors Corporation Added
MD998917
MD990930
MB990937
MD998812
MD998823
Lock pin
Differential case
Pinion shaft