Motors Automobile Parts User Manual

MANUAL TRANSMISSION (E-W) -
Center Differential <W5M42>
22B-16-3
(5) Install the front output shaft to the side gear and fit the
snap ring.
(6) Attach the spacer on the other side gear, then install the
side gear in the center differential case.
NOTE:
If a new side gear is to be installed, select a spacer with
medium thickness (0.93 - 1.00 mm).
(7) Install the center differential flange on the case while
aligning the mating marks, then secure it temporarily with
machine screw.
(8) Measure the backlash between the side gear and the
pinion.
Standard value: 0.025- 0.150 mm
(9) If th e measurement deviates from the standard value,
correct the backlash using a spacer of different thickness
and check it again.
NOTE:
The backlash must be the same on both sides.
"
D
A
CENTER DIFFERENTIAL DRIVE GEAR
INSTALLATION
(1) Apply sealant to the entire threaded portion of the bolt.
Specified sealant:
3M STUD Locking No. 4170 or equivalent
(2) Tighten the bolts to the specified torque in the illustrated
sequence.
PWEE9508-E
E
Jun. 1998Mitsubishi Motors Corporation Added
1
8
7
6
5
4
3
2
10
9