user manual

36
4.3. Terminals
Symbol Terminal Remarks Description
PA1 PLG A-phase signal input terminal
PA2 PLG A-phase inverse signal input
terminal
PB1 PLG B-phase signal input terminal
PB2 PLG B-phase inverse signal input
terminal
For information on the
pulse signals, refer to
page 30.
A and B-phase signals are input from
the PLG.
PAR A-phase terminal resistor terminal Factory-connected with "PA2" by the
jumper. Remove the jumper when the
terminal resistor is not needed.
PBR B-phase terminal resistor terminal Factory-connected with "PB2" by the
jumper. Remove the jumper when the
terminal resistor is not needed.
5V DC power (positive) input terminal
SG DC power ground terminal
4.75 to 6VDC
(Current consumption
50mA)
PLG power supply common terminals.
Input PLG power. Connect the positive
side to 5V and the ground side to SG.
Also, connect the shield of the shield
wire to SG.