Service manual

MS-A09WA MS-A12WA
OPERATING PROCEDURE PHOTOS
1. Removing the panel
(1) Remove the horizontal vane.
(2) Remove the screw caps of the panel. Remove the
screws. (Photo 1)
(3) Hold the lower part of both ends on the panel and pull
it slightly toward you, and then remove the panel by push-
ing it upward.
Photo 3
Photo 1
Photo 2
21
DISASSEMBLY INSTRUCTIONS
9
(1) Slide the sleeve and check if there is a locking lever or not.
(2) The terminal with this connector has the
locking mechanism.
Slide the sleeve.
Pull the terminal while
pushing the locking
lever.
Hold the sleeve, and
pull out the terminal
slowly.
Connector
Sleeve
Locking lever
MS-A09/12WA -
1
MS-A09/12WA
Screws of the panel
Horizontal vane
Conduit cover
Screw of the
conduit cover
Conduit plate
Terminal block
cover
Terminal block
cover
Conduit cover
Screw of the
conduit cover
<"Terminal with locking mechanism" Detaching points>
The terminal which has the locking mechanism can be detached as shown below.
There are two types (refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.