M-Series SEZ-KA Engineering Manual

SEZ Ducted Heat Pump Systems (August 2014)
SEZ-43
© 2014 Mitsubishi Electric US, Inc.
Due to continuing improvement, above specication may be subject to change without notice.
(1) Indoor Unit
Part Number Descriptions Applicable model
BRP-1
Bottom Return Plate (Converts low prole ducted indoor
unit from rear return to bottom return)
KD09
BRP-2
Bottom Return Plate (Converts low prole ducted indoor
unit from rear return to bottom return)
KD12,15
BRP-3
Bottom Return Plate (Converts low prole ducted indoor
unit from rear return to bottom return)
KD18
C13-103 Blue Diamond Sensor Extension Cable - 15 Ft.
All ModelsCN24RELAY-KIT-CM3
Relay Kit for external heater adapter connects to CN24 on
indoor control board
DPLS1
Drain Pan Level Sensor/Control for indoor unit shut off to
prevent Drain Pan Overow
FBL 1-1 FB SERIES Filter Box with MERV 8 Filters KD09
FBL 1-2 FB SERIES Filter Box with MERV 8 Filters KD12,15
FBL 1-3 FB SERIES Filter Box with MERV 8 Filters KD18
MAC-333IF-E
System Control Interface - MA, Contact terminal, and
M-NET Control Adapter, Supplemental heat and humidier
adaptor
All Models
MCCH1
Portable Central Controller (PCC) - controls up to 16
RedLINK Zones - requires an MHK1 on each indoor unit
MHK1
Wireless wall-mounted remote controller (MRCH1) with a
signal receiver (MIFH1) and cable (MRC1) all in one kit
MOS1
Outdoor Air Sensor - reads both outside temperature and
humidity displayed on MRCH1 and MCCH1 if installed
3-14. ACCESSORIES