Instruction manual

20
In case of an error during operation, you will hear an alarm tone
or will see the LED display fl ashes.
Cause/Error display
Overheat
Symptom/Remedy
[Symptom]
• When the head gets overheated, the indicator display blinks.
When overheat occurs while more than one copy is being
processed, printing starts as soon as the error is solved.
If some images are waiting to be processed, the following buttons
function as described below.
COPY button
• Each time the COPY button is pressed, the number displayed
by the indicator increases as .
• After the error is solved, copy printing starts automatically.
FEED button
• When the number of copies has been set to more than one,
outstanding copies are cancelled.
When no image remains to be processed, the buttons are valid
during overheat status. After the error is solved, copy printing starts
automatically.
[Remedy]
Wait until the head cools down.
10
ERROR DISPLAY
Cause/Error display
No paper
[Symptom]
• When the paper runs out or the paper is not installed, printing is not
possible and an alarm tone is heard.
In this case, all the buttons become non-functional.
• If this error occurs while more than one copy is being printed or
there are images waiting to be processed, printing is cancelled at
the time of the error.
Symptom/Remedy
[Remedy]
Install a new roll of paper according to “5. INSTALLATION OF
PAPER” on page 9.
When the paper is correctly installed while the printing of more
than one copy has been suspended or there are images waiting
to be processed, an alarm tone is heard. Then, printing resumes
automatically.
After the error is resolved, the unit resumes printing from the
interrupted image and fi nishes printing all the outstanding images.