Instruction manual

24
When the thermal head is dirty with dust, etc., white spots or stripes may appear on the print.
In this case, clean the thermal head by the following procedure BY USING THE SUPPLIED
CLEANING SHEET.
Roll the cleaning
sheet and install
into the set.
Press the OPEN
button.
The door opens.
Press the POWER
switch on the rear
panel to turn on the
power.
Cleaning sheet
Keep pressing the
FEED button until
you hear a beep.
Open the door.
Take out the
cleaning sheet.
Do not pull out the
cleaning sheet while
the door is closed.
Close the door
without taking out
the cleaning sheet.
Print 1-2 sheets to verify the cleaning
effect.
Press the FEED button.
Take out the cleaning sheet.
Turn on the power.
CAUTION
• It is recommended that after printing 20 rolls of paper the unit be cleaned using the supplied cleaning sheet.
• If the symptom of the dirty head is not corrected even after cleaning, your set needs repairing. Contact your dealer.
• Do not pull out the sheet and the cleaning sheet while the door is closed.
This may cause extensive damage to the unit.
• Never use other cleaning sheets. It may cause damage to the thermal head.
• This cleaning sheet should be used only for cleaning the thermal head. Do not use it for other purpose.
Insert the cleaning sheet.
Open the door.
FEED
12
USE OF CLEANING SHEET
Close the door.