User`s manual

Chapter 1: Introduction and Setup
1-6
1.3.4 Connecting the Printer
The Mitsubishi P91DW (UB) printer connections are color coded for convenience (see
figure on previous page). Plug the USB cable into the back of the printer and into the
proper USB connector on the back of the computer. Plug in the standard 3 prong power
cable to the back of the printer and to the power strip, then turn the power on.
Note: The Mitsubishi P91DW (UB) printer may be connected to any USB port on
the computer; however, the driver may need to be manually reinstalled.
The Mitsubishi CP700 and CP770 printers connect via the on-board parallel (LPT1) port.
Plug in the standard 3 prong power cable on the back of the printer and into the power
strip, then turn the power on. Set the printer up for color or black and white printing
following the directions in the owners’ manual supplied with the printer.
1.3.5 Connecting the Cabinet
The DE-500 and DE-500FC MultiImage Light cabinets connect to the back of the
computer via an RS232 cable.
Ports on the back of the cabinet and computer respectively.
Power on the cabinet after the Windows operating system has fully loaded. The
AlphaImager 2200 Imaging System is now ready for use.
Connector on the
back of the cabinet
Connector on the back
of the computer