Service manual

85
OPERATING PROCEDURE PHOTOS
Photo 13
Photo 14
Motor for
compressor
(MC)
Valve bed
Separator
Separator
fixing screw
Compressor
fixing nut
Power
receiver
Power
receiver
Outlet
Inlet
12. Removing the motor for compressor (MC)
(1) Remove the service panel. (See photo 2.)
(2) Remove the top panel. (See photo 1.)
(3) Remove the front panel. (See photo 1.)
(4) Remove the back panel. (See photo 1.)
(5) Remove the electrical parts box. (See photo 5.)
(6) Remove 3 separator fixing screws (4 ✕ 10) and remove
the separator.
(7) Collect the refrigerant.
(8) Remove 3 compressor fixing nuts by using a spanner or a
monkey wrench.
(9) Remove the welded pipe of motor for compressor inlet
and outlet.
Note: Collect refrigerant without spreading it in the air.
Receiver leg
fixing screw
Receiver leg
13. Removing the power receiver
(1) Remove the service panel. (See photo 2.)
(2) Remove the top panel. (See photo 1.)
(3) Remove the front panel. (See photo 1.)
(4) Remove the back panel. (See photo 1.)
(5) Remove the electrical parts box. (See photo 5.)
(6) Collect the refrigerant.
(7) Remove 4 welded pipes of power receiver inlet and outlet.
(8) Remove 2 receiver leg fixing screws (4 ✕ 10).
(9) Remove the power receiver together with the receiver leg.
Note: Collect refrigerant without spreading it in the air.
OC294-D-3.qxp 05.3.9 11:04 AM Page 85