Engineering Manual

Wireless Signal Receiver PAR-FA32MA-E
(5) Install the lower case on the switch box or directly on the wall.
• When installing on the switch box, seal the con-
nections between the switch box and wiring
pipe with putty.
When using the switch box
• When opening a hole using a drill for Signal Receiving Unit
cord (or taking the cord out of the back of the Signal
Receiving Unit), seal that hole with putty.
• When routing the cord via the portion cut off from the upper
case, equally seal that portion with putty.
When installing directly on the wall
(4) Seal the Signal Receiving Unit cord lead-in hole with putty in order to prevent the possible entry
of dew, water droplets, cockroaches, other insects, etc.
200 (7-7/8)
Wall
Remote control
cord (Accessory)
Wiring pipe
Locknut
Bushing
Switch box
Seal around here
with putty
Seal around here
with putty
Remote control cord
Seal around here
with putty
(6) Install the cover
Screw (M4 × 30)
∗ When installing the lower case directly on
the wall or the ceiling, use wood screws.
Refer to the installation manual for wireless remote controller for how to perform the test run.
Test Run
258