Operation Manual

►Cleaningthelters

• Clean the lters using a vacuum cleaner. If you do not have a vacuum

cleaner, tap the lters against a solid object to knock off dirt and dust.

• If the lters are especially dirty, wash them in lukewarm water. Take care

to rinse off any detergent thoroughly and allow the lters to dry completely

before putting them back into the unit.

Caution:

• Donotdrytheltersindirectsunlightorbyusingaheatsource,

suchasanelectricheater:thismaywarpthem.

• Donotwashtheltersinhotwater(above122°F[50°C]),asthis

maywarpthem.

• Makesurethattheairltersarealwaysinstalled.Operatingtheunit

withoutairlterscancausemalfunction.

Caution:

• Beforeyoustartcleaning,stopoperationandturnOFFthepower

supply.

• Indoorunitsareequippedwithlterstoremovethedustofsucked-

inair.Cleantheltersusingthemethodsshowninthefollowing

sketches.

►Filterremoval

Caution:

• Inremovingthelter,precautionsmustbetakentoprotectyour

eyesfromdust.Also,ifyouhavetoclimbuponastooltodothe

job,becarefulnottofall.

• Whenthelterisremoved,donottouchthemetallicpartsinside

theindoorunit,otherwiseinjurymayresult.

►Removalandreplacementoflter

• Unscrew the two thumb knobs on the panel stamped “lter” tilt forward

and pull the panel out. Grasp the edge of the lter and slide out.

Re-install in reverse. (see Fig A)

5.CareandCleaning

■ PVA-A·AA7

4.Timer

■ Timer functions are different by each remote controller.

■ For details on how to operate the remote controller, refer to the appropriate operation manual included with each remote controller.

FILTER

Filter

Fig A