PVA-A42AA7 Specs

ManualsBrandsMitsubishi ManualsCooling42k BTU Cooling + Heating - P-Series H2i Multi-Position Air Handler Air Conditioning System - 15.3 SEER

Table Of Contents

Job Name:

System Reference: Date:

Indoor Unit:

PVA-A42AA7

Outdoor Unit:

□ PUY-A42NKA7

□ PUY-A42NKA7-BS

INDOOR UNIT FEATURES

• Ducted air handler provides a solution to cool and heat large zones

• Highly efficient totally enclosed ECM motor

• Selectable external static pressure: 0.30, 0.50 and 0.80 in.WG with 3 fan speeds at each static setting

• 1 inch R4.2 fiberglass free insulation reduces condensation and boosts efficiency

• Positive pressure cabinet with air leakage of less than 1.0% at 1.0 in.WG

• Unique blow through design allows simple coil cleaning when the blower is removed

• Multi-position installation: horizontal (left or right), vertical (up or down). For downflow configurations, the CMA-1 is recommended for proper

management of condensate to prevent water blow-off in certain conditions

• Optional electric heat kit for additional heat capacity

• Optional humidifier control and ERV control

OUTDOOR UNIT FEATURES

• Variable speed INVERTER-driven compressor

• Power receiver pre-charged with refrigerant volume for piping length up to 100 ft (70 ft. for A12/18/24/30)

• Low ambient cooling down to -40ºF providing 100% capacity (only for PUY models with wind baffles installed)

• 24-hour continuous operation (cooling mode)

• High pressure protection

• Fast restarts in cooling mode (15 seconds for 12/18/36/42; 50 seconds for 24/30)

• Superior energy and operational efficiency

SUBMITTAL DATA: PVA-A42AA7 & PUY-A42NKA7(-BS)

42,000 BTU/H AIR HANDLER AIR-CONDITIONING SYSTEM

P-SERIES

Summary of content (7 pages)

PAGE 1
P-SERIES SUBMITTAL DATA: PVA-A42AA7 & PUY-A42NKA7(-BS) 42,000 BTU/H AIR HANDLER AIR-CONDITIONING SYSTEM Job Name: System Reference: Indoor Unit: PVA-A42AA7 Date: Outdoor Unit: □ PUY-A42NKA7 □ PUY-A42NKA7-BS INDOOR UNIT FEATURES • Ducted air handler provides a solution to cool and heat large zones • Highly efficient totally enclosed ECM motor • Selectable external static pressure: 0.30, 0.50 and 0.80 in.WG with 3 fan speeds at each static setting • 1 inch R4.
PAGE 2
SPECIFICATIONS: PVA-A42AA7 & PUY-A42NKA7-BS Indoor Unit Model Number Cooling1 PVA-A42AA7 PUY-A42NKA7 Outdoor Unit PUY-A42NKA7-BS Maximum Capacity Btu/h 42,000 Rated Capacity Btu/h 42,000 Minimum Capacity Btu/h 15,000 Maximum Power Input W 4,150 Rated Power Input W 4,150 Moisture Removal Pints/h 7.2 Sensible Heat Factor Power Factor Efficiency 0.81 % SEER 18.00 EER1 10.
PAGE 3
SPECIFICATIONS: PVA-A42AA7 & PUY-A42NKA7-BS Indoor Unit Model Number PVA-A42AA7 PUY-A42NKA7 Outdoor Unit PUY-A42NKA7-BS Airflow Rate CFM Refrigerant Control Electronic Expansion Valve Heat Exchanger Type Sound Pressure Level, Cross fin Cooling1 dB(A) Inverter-driven twin rotary Compressor Model MNB33FBRMC-L Compressor Rated Load Amps A 8 Compressor Locked Rotor Amps A 13 oz. FV50S // 45 External Finish Color Ivory Munsell 3Y 7.8/1.1 Base Pan Heater n/a W: In.
PAGE 4
ACCESSORIES: PVA-A42AA7 Signal Receiver □ PAR-SA9CA-E Wireless Remote Controller □ PAR-FL32MA-E Wireless Remote Receiver □ PAR-FA32MA-E Backlit, Wall-mounted, Wireless Controller □ MHK1 Portable Central Controller □ MCCH1 Wired MA Controller □ PAR-33MAA Simple MA Controller □ PAC-YT53CRAU Touch MA Controller □ PAR-CT01MAU-SB Wired Remote Sensor □ PAC-SE41TS-E Wireless Temperature and Humidity Sensor □ PAC-USWHS003-TH-1 Outside Air Sensor for MHK1 □ MOS1 Wireless Interface □ PAC-USWHS0
PAGE 5
ACCESSORIES: PUY-A42NKA7(-BS) Air Outlet Guide □ PAC-SH96SG-E (two pieces are required) Front Wind Baffle □ WB-PA3 (two pieces are required) Side Advanced Wind Baffle □ WB-SD6 Rear Advanced Wind Baffle □ WB-RE6 Drain Socket □ PAC-SG61DS-E M-NET Converter □ PAC-SF83MA-E M-NET Converter □ PAC-SJ95MA-E Control/Service Tool □ PAC-SK52ST Condensing Unit Mounting Pad 24" x 42" x 3" □ ULTRILITE2 Outdoor Unit Stand—12" High □ QSMS1202M Outdoor Unit Stand—18" High □ QSMS1802M Outdoor Unit Stand
PAGE 6
PVA-A42AA7 Unit:mm(in.) Unit:mm(in.) Note 1.1.Keep these service space for for maintenance maintenanceatatthe thefront front.. Note Keep the rvice space ø26 Kno Knockout Hole ø26 ckout Hole (Remotecontroller controllert transmission) (Remote ransmission) 8(3/8) 8(3/8) 92(3-5/8) 92(3-5/8) 30(1-3/16) 30(1-3/16) H G G Seconda ry drain pipe Secondary pipe (Emergency ddraining) raining) (Emergency ø19.05(3/4) 3/4"FPT ø19.
PAGE 7
DIMENSIONS: PVA-A42AA7 & PUY-A42NHA7 (-BS) Unit: mm Piping and wiring connections can be made from 4 directions: FRONT, Right, Rear and Below. Installation Feet 50 <2> 330 <13> Max. Min. 70 <2-3/4> Air Discharge Side Air Intake 362 <14-1/4> Rear Air Intake 60 <2-3/8> 2-12×36 Oval holes (Foundation Bolt M10) 1050 <41-11/32> ( Earth terminal 53 <2-3/32> 42 <1-21/32> Terminal connection Left ... Power supply wiring Right ... Indoor/Outdoor wiring ) Example of Notes 1 ...