User`s manual

6 - 9 6 - 9
MELSEC-Q
6 PROGRAMMING
(b) Auto refresh setting (see Section 5.5)
CH1 Digital output value..................."W11"
CH2 Digital output value..................."W12"
CH3 Digital output value..................."W13"
Error code ........................................."W14"
(c) Writing the intelligent function module parameters (see Section 5.3.3)
The intelligent function module parameters are written to the remote I/O
station.
This operation is performed using the parameter setting module selection
screen.
(3) Programming example
Read the A/D conversion
completed flag
Read the CH1 digital output value
Read the CH2 digital output value
Read the CH3 digital output value
Output the error code in BCD
Turn ON the error clear
request (YF)
Turn OFF the error clear
request (YF)
Digital output value read
Error code display and reset
POINT
To write the intelligent function module parameters, set the target remote I/O station
from [Online] - [Transfer setup] on GX Developer.
They can be written by:
• Directly connecting GX Developer to the remote I/O station.
• Connecting GX Developer to another device such as a CPU module and
passing through the network.