User`s manual

4 - 3
4.2 Operating Procedure of Predefined Protocol Support Function
1
OVERVIEW
2
COMMON OPERATIONS FOR INTELLIGENT FUNCTION MODULES
3
OPERATING INTELLIGENT FUNCTION MODULES
4
PREDEFINED PROTOCOL SUPPORT FUNCTION
A
APPENDIX
I
INDEX
4.2 Operating Procedure of Predefined Protocol Support Function
This section shows the operating procedure for writing protocols to the module using the predefined protocol
support function.
● Executing a predefined protocol by a dedicated instruction
To execute a predefined protocol, a program to execute the dedicated instruction (CPRTCL instruction) is required.
For details of the dedicated instruction, refer to the following manual.
User's manual of each module
When using the dedicated instruction in structured ladder/FBD, refer to the following manual
MELSEC-Q/L Structured Programming Manual (Special Instructions)
Open the Protocol Setting screen
Start up the predefined protocol support function
Exit the predefined protocol support function
Add a protocol to be used
YES
NO
Set the protocol as an editable one?
Select a registered protocol from
the predefined protocol library
Configure details of the protocol
Write protocols to a module
Section 4.6.1
Section 4.6.1
Section 4.5.1
Section 4.5.2
Section 4.6
Section 4.7
Section 4.6.1
Section 4.8.1
Section 4.3
Section 4.3