User`s manual

INDEX - 3
1
OVERVIEW
2
COMMON OPERATIONS FOR INTELLIGENT FUNCTION MODULES
3
OPERATING INTELLIGENT FUNCTION MODULES
4
PREDEFINED PROTOCOL SUPPORT FUNCTION
A
APPENDIX
I
INDEX
[O]
Offline simulation ............................................................3-40
Offset and gain settings
............................................ 3-2, 3-8
option
..............................................................................3-53
[P]
packet element ...............................................................4-19
packet setting
.................................................................4-19
Positioning Data Copy
....................................................3-37
Positioning Data Paste
...................................................3-37
Positioning start test
.......................................................3-23
Positioning test
...............................................................3-20
predefined protocol support function
................................4-1
Preset function
................................................................3-14
properties of intelligent function modules
.......................2-11
Property
..........................................................................2-11
Protocol Detailed Setting
................................................4-13
protocol execution log
.....................................................4-36
protocol setting
..................................................... 4-10, 4-36
protocol setting data error
...............................................4-32
protocol setting file
............................................................4-9
[Q]
QD70 positioning module ...............................................1-15
QD75 positioning module
.............................................. A-16
QD75/LD75 positioning module
............................A-16, 1-13
QD75M/QD75MH
.......................................................... A-16
[R]
Register Module Information ................................ 2-26, 2-27
Requesting parameter initialization and flash ROM write
........................................................................................3-34
reserved module
...............................................................2-4
[S]
Scale Initial Setting ...........................................................3-6
send (receive) data storage area
....................................4-27
Sensor Correction
...........................................................3-12
serial communication module
................................. 3-49, 4-1
serial communication/modem interface module
.............1-16
Set Default Value
............................................................3-36
Set Maximum Value
.......................................................3-36
Set Minimum Value
........................................................3-36
simple motion module
.....................................................1-15
Simple Motion Module Setting
........................................3-48
Simulate Calculation Result
.................................. 3-42, 3-44
size
.................................................................................3-53
Speed change test
..........................................................3-26
state monitor
...................................................................4-38
Static Data
......................................................................4-22
status bar
..........................................................................4-6
stop by occurrence of timer 0 time-out error
...................3-53
stop setting
.....................................................................3-53
switch setting
............................................................ 2-4, 2-6
[T]
temperature control module ...........................................1-12
temperature input module
..............................................1-11
two-point calibration
.........................................................3-5
two-point span calibration
.................................................3-6
two-point zero calibration
.................................................3-6
[W]
Wave trace .....................................................................3-28