Operation Manual

– 5 –
Startup Screen
[Startup Screen]
This screen is displayed at startup.
[Login screen]
The default ID and password are as follows:
Default ID:
Default password:
OPERATOR
123456
After logging in, change the default ID and password to your own.
Changing the ID and password
page 32
[Information Screen]
Note
It is not possible to do any setting when information screen is displayed.
ALL GROUPS Display•
This display appears the fi rst time the unit starts up or when block have not been registered. Make the initial settings
in the following order.
Time & Date Setting page 26
Group Defi nition page 23
Block Defi nition page 25
Once blocks are registered, it is very convenient because the status of all groups can be viewed on a single *
screen.
ALL BLOCKS Display•
When blocks have been registered, this display appears.
Note
It may take time for the settings to be read into the unit. Do not perform any operations until all the groups
that have been set are displayed. (This should take only a few minutes.)