Installation guide

6.5
[Fig. 6-10]
Max. 20m [65 ft]
15-2 m [5 to 7 ft]
ae)
®
[Fig.6-11]
(Unit:
mm
[in])
® Indoor unit
® Pipe cover (60 mm [3/8 in]) (accessory)
© Tie band (accessory)
© Visible part
® Insertion margin
® Drain hose (accessory)
© Drain pipe (O.D. 232 mm [1-1/4 in] PVC TUBE, field supplied)
@ Insulating material (field supplied)
Tie band (accessory)
@ Max.180 + 5 mm [7-3/32 + 7/32 in]
© Correct piping
> Wrong piping
® Insulation (9 mm [3/8 in] or more)
® Downward slope (1/100 or more)
© Support metal
® Air bleeder
aa © Raised
@ Odor trap
Grouped piping
® 0. D. 632 mm [1-1/4 in] PVC TUBE
® Make it as large as possible. About 10 cm [3-15/16 in].
® Indoor unit
@© Make the piping size large for grouped piping.
@ Downward slope (1/100 or more)
@ ©. D. 938 mm [1-1/2 in] PVC TUBE for grouped piping.
(9 mm [3/8 in] or more insulation)
@ Up to 550 mm [21-21/32 in]
@ Drain hose (accessory)
© Horizontal or slightly upward
[Fig.6-12]
® No gap. The joint section of the insulation material must meet at the top.
®
® indoor unit
® Pipe cover (30 mm [3/16 in]) (accessory)
© Tie band (accessory)
® Band fixing part
© insertion margin
® Drain hose (accessory)
© Drain pipe (O.D. 932 PVC TUBE, field supplied)
@ insulating material (field supplied)
@ Max.145 +5 mm
6.6
[Fig. 6-13]
® Insert pump's end 2 to 4 cm [13/16 to 1-19/32 in].
® Remove the water supply port.
© About 2 liters
@® Water
© Filling port
® Screw
[Fig. 6-14]
SWE
«Indoor board>