Specifications
5
3. Operation
AAA
AAA
CLOCK
CHECK
RESET
SET
TEST RUN
MODE
FAN
VANE
LOUVER
min
h
AUTO START
AUTO STOP
ON/OFF
TEMP
1
A
3-stage
2-stage
( )
(
)
(Middle)
Fan speed
Remote controller display
(Auto) Low Middle 2 Middle 1 High
4-stage
( )
4.1. For wireless remote controller
1) Set the current time
1 Press the CLOCK button using a thin stick and blink the time A.
2 Press the
h
and
min
button to set the current time.
3 Press the CLOCK button using a thin stick.
2) Set the time to start the unit as follows
1 Press the
AUTO START
button.
• Time can be set while the following symbol is blinking.
On time: B START is blinking.
• The start times is displayed at A.
2 Use the
h
and
min
buttons to set the desired time.
3 To cancel the ON timer, press the
AUTO START
button.
3) Set the time to stop the unit as follows
1 Press the
AUTO STOP
button.
• Time can be set while the following symbol is blinking.
Off time: C STOP is blinking.
• The stop times is displayed at D.
2 Use the
h
and
min
buttons to set the desired time.
3 To cancel the OFF timer, press the
AUTO STOP
button.
4) Changing the set times
Press the
AUTO START
or
AUTO STOP
to cancel the timer and repeat from 2) or 3).
4. Timer
AAA
AAA
CLOCK
CHECK
RESET
SET
TEST RUN
MODE
FAN
VANE
LOUVER
min
h
AUTO START
AUTO STOP
ON/OFF
TEMP
13
2
D
A
C
B
5. Emergency Operation for Wireless Remote-controller
ON/OFF
HEAT COOL
2
1
1 ON/OFF lamp (lit when unit is operating; unlit when unit is not operat-
ing)
2 Emergency operation
In cases where the remote control unit does not operate properly, use
either the COOL or HEAT button on the wireless remote control
signal receiver to toggle the unit on or off. On cooler only units, pushing
the HEAT button toggles the fan on and off.
Pressing the COOL or HEAT button selects the following settings.
Operation mode COOL HEAT
Preset temperature 24 °C/75 °F 24 °C/75 °F
Fan speed High High
3.5. Fan speed setting
■ Press the Fan Speed button 1 as many times as necessary while the
system is running.
• Each press changes the force. The currently selected speed is shown
at A.
• The change sequence, and the available settings, are as follows.
1 Press
FAN
button to select a desired fan speed.
• Each time you press the button, available options change with the
display A on the remote controller, as shown next.
The wind speeds that can be selected depend on the model.
Note that some units do not provide an “Auto” setting.
The display and the fan speed of the unit will differ in the following situ-
ations:
• When the unit is in STAND BY mode or in DEFROST mode.
• Just after the heating mode (while waiting to change to another mode).
• When the temperature of the room is higher than the temperature
setting of the unit operating in the heating mode.
• In the dry operation, the indoor fan automatically turns to low-speed
operation. Switching of fan speed is impossible.
3.6. Ventillation
ss
ss
sFor LOSSNAY combination
3.6.1. For Wireless Remote-controller
● The ventillator will automatically operate when the indoor unit turns on.
● No indication on the wireless remote controller.
KB79H174H01_en.pm6 07.7.11, 9:13 AM5