Indoor Installation Manual
Table Of Contents
- SVZ-KP12,18, 24, 30, 36NA
- Table of Contents
- SVZ-KP12,18, 24, 30, 36NA
- 1. Dimensions
- 2. Inspect shipment
- 3. Safety precautions
- 4. Indoor unit accessories
- 5. Selecting an installation site
- 6. Combining indoor units with outdoor units
- 7. Installing the unit
- 8. Side Return
- 9. Duct connection
- 10. Mount positions
- 11. Air filter
- 12. Refrigerant piping work
- 13. Drain connections
- 14. Electrical wiring
- 15. Test run
- SVZ-KP12,18, 24, 30, 36NA
- 1. Dimensions
- 2. Inspection du matériel livré
- 3. Mesures de sécurité
- 4. Accessoires de l’appareil intérieur
- 5. Sélection de l’emplacement d’installation
- 6. Combinaison des appareils intérieurs et extérieurs
- 7. Installation de l’appareil
- 8. Retour latéral
- 9. Raccordement des conduits
- 10. Positions de montage
- 11. Filtre à air
- 12. Travaux de tuyauterie de frigorigène
- 13. Raccordements de vidange
- 14. Câblage électrique
- 15. Essai de fonctionnement
- 15.1. Avant l’essai de fonctionnement
- 15.2. Essai de fonctionnement
- 15.3. Autotest
- 15.4. FONCTION D’AUTOREDÉMARRAGE
CAUTION
Do not use anything other than the correct capacity breaker and fuse. Using fuse, wire or
copper wire with too large capacity may cause a risk of malfunction or fire
After wiring is complete, make sure again that there is no tension on the connections, and attach the cover
onto the control box in the reverse order removal. Also, seal any openings created from wiring into the air
handler. This will prevent air leakage.
CAUTION
Wire the power supply so that no tension is imparted. Otherwise disconnection, heating or
fire may result.
IMPORTANT
Attach shielding ground on the outdoor unit’s ground terminal.
If the remote controller cable exceeds 10 m [32 ft.], use a 1.25 mm
2
[AWG16] diameter cable over the ex-
ceeded portion, and add that exceeded position to within 200 m [656 ft].
@
D
O
� �
D
@
@
D
0
0
@
DD
D
D
J
D
B
�
J
D
J
J
J
0
@
J
@
D
@
�
D
@
J
D
J
I
0
@
①
②
③
④
⑤
① CONTROL BOARD
② INVERTER BOARD
③ TO REMOTE CONTROLLER I , 2
④ GROUNDING TERMINAL
⑤ SI, S2, S3
SVZ-KP12,18, 24, 30, 36NA
Specifications are subject to change without notice. 43 © 2022 Mitsubishi Electric US, Inc.
ENGLISH