Operating instructions

2. Otherwise, select Start Inputs from the Rip-
Mate menu in RipMate.
The connection to the front-end will now be estab-
lished.
Monitoring the RIP
The RipMonitor/System Monitor displays a log of
the RIP as shown below.
1. If the above window does not appear, select
Rip Monitor from the RipMate pull-down
menu.
The most important error messages are:
Missing font
The name of the missing font.
Missing calibration
A selected calibration is no longer present.
PostScript™ fault
A bad or too complicated PostScript file has been
sent.
Monitoring the DPX SYSTEM Unit
BUSY/INFO
Information about which function the DPX SYS-
TEM is performing at a given point of time.
The above example shows the DPX SYSTEM in
stand-by mode with no plates being processed.
INFO
The boxes in the INFO window work as a status
bar showing the position of the plates.
Lo: Plate loading. The plate is being fed from roll
magazine A or B into the drum.
Ex: Exposure Cut. The knife is cutting the plate.
Fe: The plate is being fed from the drum into the
buffer.
P1: The plate is in the activator tank.
P2: The plate is in the stabilizer tank.
Dry: The plate is in the drying module.
ERROR
If an error/fault occurs, this window will inform
about the cause of the problem.
Interlock: The processor door is not closed.
Page 8
Monitoring the RIP DPX System Operating Instructions
555 Theodore Fremd Ave., Rye, NY 10580 • 914-925-3261 • http://techsupport.mitsubishiimaging.com