Operating instructions

Liquid Level: The level in the activator tank is to
low. Change the chemistry or refill the replenish-
ment bottles
Drive Load: The processor stopped due to over-
load of the processor motor. Check whether there
is a plate in the processor section.
Dryer Exit: Jam in the processor section. Open the
processor and make sure that no plates are
jammed.
Loader Jam: Jam in the exposure section. The
fault numbers refer to the following:
Fault number 0-100: Something in the exposure
section went wrong during a sequence. Shutting
down the system, remove any plate pieces in the
drum, and restart the system.
Fault number 110-112: A jam in the punch tools.
Shut the system down and clean the tools before
restarting the system.
If a plate jam error occurs, shut down the system,
remove the jammed plate before restarting the
system. If plate jam reoccurs, contact the local
service engineer.
FAIL
Vaccum fail: The vaccum level was incorrect. Ex-
amine the plate and repeat the job if necessary. If
the fail reoccurs, contact the local service engineer.
Activator temp: The temperature deviates more
than 2°C from the specified developer temperature.
Do not process a plate until the temperature is cor-
rect.
Dryer Temp: The dryer temperature deviates more
than 2°C from the specified dryer temperature. The
plates might not be completely dry when they
come out.
Drive Tacho: The processor is not running. Check
the processing section for jams, and make sure the
activator and stabilizer tanks are not covered with
dirt. If everything seems in order, and the processor
is still not running, contact the local service engi-
neer.
Temperatures
Indicates the actual temperature in the activator
tank and in the drying unit.
Changing Plate Material
Unloading material
The following description set forth that the system
is installed and setup according to the installation
instructions and user guide.
1. Stop processing by activating the Disable out-
put button. See section “Start/stop processing”.
2. Activate the RipManager icon by double click-
ing on it.
3. Select Media Management from the DPX
SYSTEM pull-down menu.
The following window appears:
Page 9
DPX System - Operating Instructions Changing Plate Material
555 Theodore Fremd Ave., Rye, NY 10580 • 914-925-3261 • http://techsupport.mitsubishiimaging.com