Operating instructions

TEM, due to Windows NT system or another
programme.
1. Try repeating the job.
Undefined command “set calibration”
The current plate setup can not find a calibration.
This might be due to the setup of the calibration or
how the received PostScript job was set up. Refer
to the RipMate user guide for further information.
Font not found
The system is set up to refuse processing a plate
when a font is missing in the PostScript job.
DPX SYSTEM reports to the Rip Monitor which
font is missing.
Loader Jam:0-100
An error in the exposure section of the DPX SYS-
TEM has occured. Generally, this error message
describes a situation, where a sensor has not seen
the material passing by at the expected time.
1. Shut down the system and restart it.
Continue exposing if the error has disappeared,
otherwise
2. Shut down the system.
3. Open the exposure module door (fig. 2. G).
Warning: All power to the machine is now shut
off. Wait 20 seconds for the spinner motor to set-
tle.
4. Look for plate material left in the drum.
5. With the palm of the hand against the drum
surface, scan the surface to make sure that no
pieces are left.
6. Close the exposure module door (fig. 2. G),
and restart the system.
Loader Jam: 101 - 112
This error only occurs when a punch system is in-
stalled.
1. Shut down the system.
2. Open the exposure module door (fig 2. G).
Warning: All power to the machine is now shut
off. Wait 20 seconds for the spinner motor to set-
tle.
Page 16
Troubleshooting DPX System Operating Instructions
555 Theodore Fremd Ave., Rye, NY 10580 • 914-925-3261 • http://techsupport.mitsubishiimaging.com