Operator`s manual

nameo’
UWiE fJXUSUSTM 50 INCH Operator’s Manual
5.3.2 Replacing the Gun Solenoid
I,
Remove the gun covers and gun side halves.
M4 X 6 Cap Screw
?
Slide
t Solenoid Bracket
Ground
Wire
Lock Washer
hi3 X 8 Cap Screw
Figure 5-2 Gun Solenoid Assembly
2. Disconnect the solenoid connector.
3. Remove the M3 x IO cap screw attaching the solenoid/slide assembly to
the left gun cover.
4. Remove the M3 x 8 cap screw and washer attaching the ground wire to
the solenoid bracket.
5. Loosen the solenoid nut.
6. Pull the solenoid away from the bracket.
7. Remove the two M4 x 6 cap screws attaching the slide guide to the
bracket.
8. Remove the solenoid plunger and spring.