Operating instructions

setting up the remote control to operate other brands of equipment.

† Turn on your VCR, Cable Box or other equipment.

¢ Set the select switch on the remote to the layer you want to set up:

VCR or DVD/CABLE or AUDIO.

£ While holding in the POWER key on the remote control, enter the code

number listed for your brand of equipment. The code number can be

found in the charts following these instructions. Be sure to enter both

digits of the code number. If more than one code number is listed, start

with the first code number.

® Release the POWER key, point the remote at the equipment you are

trying to set up the remote to control and press the POWER key again.

If the equipment turned off, the remote is ready to control that equip-

ment. If the equipment did not turn off, repeat the instructions using

the next code listed for that brand.

work, try all of the codes for the equipment type. For VCR’s try codes

01 to 21. For Cable Boxes and Satellite Receivers try codes 47-99.

§ To reset an individual layer to its initial setting, follow the setup

instructions and use 00 as the code number.

Important: After setting up your remote control, if you cannot turn on the

cable box by pressing POWER, try using the CHANNEL button or

number buttons. Some cable boxes will turn on when a channel is

requested.

⁄Important: Sometimes manufacturers will change their products, or they may

use more than one remote control system. If this is the case, your

remote may not be able to operate your VCR, Cable Box or Satellite

Receiver.

⁄Important: When you replace the batteries in your remote control, the remote

will usually return to its initial setting. You may need to set up

your remote again.

If you are using TV GUIDE Plus+, do not turn the cable box off. Always leave

the cable box on.

Using the remote control to operate VCRs, cable boxes

and other equipment (cont.)

Overview of the Remote Control