Manual

Projection TV + antenna or cable with a decoder
box
equipment you_l need
Use this hook-up if you need a decoder box to descramble cable signals.
This hook-up wil! allow you to use the remote control to change
channels.
To complete the hook-up, you'll need:
1 two-way splitter, and
3 lengths of 75 ohm coaxial
cable.
procedure
(See illustration on the following page.)
O Connect the incoming cable to the ]:N terminal on the two-way
splitter.
O Connect a coaxial cable to one of the OUT terminals on the same
splitter; connect the other end of this cable to the ANT-A terminal
on the back of the Projection TV.
Connect the second coaxial cable to the s_,cond OUT terminal on the
same splitter; connect the other end of this cable to the IN terminal
on the decoder box.
O Connect the third coaxial cable to the OUT terminal on the back of
the decoder box, and the other end of this cable to the _'_qT-B termi-
nal on the back of the Projection TV.
Basic Connections 31