Manual

_>
Important:
Important:
procedure
(See illustration on the following page.)
O Connect the incoming antenna to the IN terminal on the two-way
splitter.
O Connect a coaxial cable to one of the OU:? terminals on the two-way
splitter; connect the other end of this cable to the ANT-A terminal
on the back of the television.
Connect a second coaxial cable to the ol:her OUT terminal on the
two-way splitter. Connect the other end of this cable to the VHF-IN
terminal on the back of the VCR.
Connect an RCA pin type video cable _o the VIDEO OUT terminal
on the back of the VCR. Connect the other end of this cable to the
VIDEO INPUT terminal on the back of the televisio_a.
If you are connecting a Super VHS (S-VHS)VCR, use a Super Video ca-
ble instead of an RCA pin type video cable. Connect a Super Video c_
ble to the S-VIDEO OUT terminal on the VCR. Connect the other end
of this cable to the S-VIDEO INPUT terminal on the back of the
Projection TV.
O Connect a set of RCA pin type audio cables to the AUDIO OUTPUT
terminals on the back of the VCR. Use the red cable to connect the
right (R) channel and the white cable :."orconnecting the left (L)
channel.
O Connect the other ends of this cable to the AUDIO INPUT termi-
nals on the back of the Projection TV.
If your VCR is monaural (non-stereo), you will only connect a single
RCA pin type audio cable. Connect the cable to the VCR, then connect
the other end to the L (LEFT) audio input on the back of the Projection
TV.
Set the VCR to the playback mode.
0 Select the desired external input source on the TV (1 or 2) by using the
INPUT buttons on the front panel or remote control.
Basic Connections 35