Manual

Important:

Projection TV + VCR + antenna or cable with a

decoder box (continued)

procedure

(See illustration on the following page.)

0 Connect the incoming cable to the IN terminal on the first two-way

splitter.

O Connect a coaxial cableto one of the OUT termiasls on the same

splitter; connect the other end of this cable to the ANT-A terminal

on the back of the Projection TV.

O Connect a second coaxial cable to the other OUT terminal on the

same splitter; connect the other end ofthis cable to the IN terminal

on the decoder box. "

O Connect the third coaxial cable to the OUT termi sal on the back of

the decoder box; connect the other end of this cab].e to the IN termi-

nal on the second two-way splitter.

Connect the fourth coaxial cable to one of the Ol.Y]:terminals on title

second two-way splitter. Connect the other end of this cable to the

ANT-B terminal on the back of the .Projection TV.

0 Connect the fifth coaxial cable to the other OUT terminal on the

same splitter. Connect the other end of this cable to the VHF-IN ter-

minal on the back of the VCR.

0 Connect an RCA pin type video cable to the VIDE() OUT terminal

on the back of the VCR. Connect the other end of this cable to the

VIDEO INPUT terminal on the back of the Projection TV.

If you are connecting a Super VHS (S-VHS) VCR, use a Super Video ca-

ble instead of an RCA pin type video cable. Connect a Super Video ca-

ble to the S-VIDEO OUT terminal on t:he VCR. Connect the other end

of this cable to the S-VIDEO INPUT terminal on the back of the

Projection TV.

0 Connect a set of RCA pin type audio cables to the AUDIO OUTPUT

terminals on the back of the VCR. Use the red cable to connect :_he

right (R) channel and the white cable for connecting the left (L)

channel.

0 Connect the other ends of this cable to the AUDIO INPUT termi-

nals on the back of the Projection TV.

If your VCR is monaural (non-stereo), you will only connect a single

RCA pin type audio cable. Connect the cable to the VCR, then connect

the other end to the L (LEFT) audio input on the back of the Projection

TV.

O Set the VCR to the playback mode.

Select the desired external input source on the TV (1 or 2) by using the

INPUT buttons on the control panel or remote conlxol.

38 Chapter 2: Connecting Your ProjectionTV