Manual

Programming the remote control (cont.)
O Press and hold the corresponding button on the other remote conl_'ol
unit until the learning indicator "1" turns off. "¢_en the button
is released, the learning indicator "2" will light up.
Repeat steps @ -- @ for learning other funclioas.
• Press the learn button again. The learning indicators "1" and "2"
will turn off.
Depending on the unit, some commands may not be learned by steps
@ to @. In this case, try steps @ -- @ once again, and press
and hold the same button again until both learning indicators "1"
and "2" light up.
If the distance between two remote control units in step (_) is too
short or too long, the learning process may not be completed. In
this case, changethe distance between the two remote control umts
a little and then repeat steps @ --- @ once ag_a.
• The buttons can re-learn new commands by following the steps (3
-- (_) again.
canceling the learned functions
To erase the learned function of each button:
• Press the learn button (LEARN/NORM) using a pen. The learnfllg
indicators "1" and "2"' will light up.
O Press the button whose learned function is to be erased. Press the
learn button again.
50
Chapter 3: Operating Your Projection TV