Specifications

MAINTENANCE SERVICE

TSB Revision

GENERAL

00-41

MAINTENANCE SERVICE

1. FUEL SYSTEM (TANK, PIPE LINE AND

CONNECTION, AND FUEL TANK FILLER TUBE

CAP) (CHECK FOR LEAKS)

M1001001600141

Check for damage or leakage in the fuel lines and connections.

2. FUEL HOSES (CHECK CONDITION)

M1001001700148

1. Inspect the surface of fuel hoses for heat and mechanical

damage. Hard and brittle rubber, cracking, tears, cuts,

abrasions and excessive swelling indicate deterioration of

the rubber.

2. If the fabric casing of the rubber hose is exposed by cracks

and abrasions in the fuel system, the hoses should be

replaced.

3. AIR CLEANER ELEMENT (REPLACE)

M1001001800231

The air cleaner element will become dirty during use, reducing

its effectiveness. Replace it with a new one.

REPLACEMENT OF AIR CLEANER ELEMENT

AC201018

1. Unclamp the air cleaner housing.

2. Remove the air cleaner element and install a new one.

3. When clamping the air cleaner housing in place, be sure that

the cover is completed closed.

4. EVAPORATIVE EMISSION SYSTEM (EXCEPT

EVAPORATIVE EMISSION CANISTER) (CHECK

FOR CLOGGING)

M1001001900142

If the fuel-vapor vent line is clogged or damaged, fuel vapor will

escape into the atmosphere causing excessive emissions. Dis

connect the line at both ends, and blow it clean with com-

pressed air. Remove the fuel tank filler tube cap from the filler

tube and check to see if there is evidence that the seal makes

improper contact to the filler tube.