Specifications

AC000093
MB991610 OR
GENERAL
SERVICE
TOOL
AG
MAINTENANCE SERVICE
TSB Revision
GENERAL
00-46
4. Use an oil filter wrench to remove the engine oil filter.
5. Clean the filter bracket side mounting surface and ensure
the old O-ring has been removed.
ACX00396
O-RING
AB
6. Apply a small amount of engine oil to the O-ring of the new
oil filter.
7. Screw on the oil filter by hand until it touches the surface of
the flange and then tighten it with an oil filter wrench.
NUMBER SPECIAL TOOL TIGHTENING TORQUE
MD356000 MB991610 or equivalent Approximately 3/4 turn [14 ± 2 N⋅ m (124 ± 18 in-lb)]
MD136466
MD322508
General service tool Approximately 3/4 turn [17 ± 3 N⋅ m (34 ± 2 ft-lb)]
8. Install the drain plug and refill engine oil (Refer to Engine Oil
Replacement
P.00-44).
9. Rev the engine a few times, and check to be sure that no
engine oil leaks from the installation section of the oil filter.
12. MANUAL TRANSAXLE OIL
M1001002800278
CHECKING TRANSAXLE OIL LEVEL
AC102278
AD
FILLER PLUG
TRANSMISSION
OIL
FILLER PLUG
HOLE
1. Remove the filler plug.
2. Check that the oil level is up to the lower edge of the filler
plug hole.
3. Check that the oil is not noticeably dirty.
4. Tighten the filler plug to the specified torque.
Tightening torque: 32 ± 2 N⋅ m (24 ± 1 ft-lb)