Specifications

MAINTENANCE SERVICE
TSB Revision
GENERAL
00-49
Approximately 3.5 dm
3
(3.7 quarts) of transmission
fluid should be added.
NOTE: Check for contamination or a burnt odor. If the trans-
mission fluid is still contaminated or burnt, repeat Steps 6
and 7 before proceeding to Step 8.
AC103690
AC
8. Reconnect the hose which was disconnected in step 1
above, and firmly replace the dipstick.
9. Start the engine and run it at idle for one to two minutes.
10.Move the selector lever through all positions, and then move
it to the "N" position.
AC005861AB
11.Check that the transmission fluid level is at the "COLD"
mark on the dipstick. If the level is less than this, add
transmission fluid.
12.Drive the vehicle until the transmission fluid temperature
rises to the normal operating temperature [70
− 80° C (158 −
176
° F)], and then check the transmission fluid level again.
The transmission fluid level must be at the "HOT" mark.
NOTE: The transmission fluid temperature is measured with
scan tool MB991958 (
MUT-III sub assembly).
NOTE: The "COLD" level is for reference only; the "HOT"
level should be regarded as the standard level.
NOTE:
AC304814
HOT
80
DIPSTICK
6040
(176)(140)(104)
FLUID TEMPERATURE [˚C (˚F)]
– 30 (– 1.2)
– 20 (– 0.8)
– 10 (– 0.4)
0 (0)
10 (0.4)
FLUID LEVEL [mm (in)]
AB
(68)
20
If it takes some amount of time until the transmission
fluid reaches its normal operating temperature [70
− 80 ° C
(158
− 176 ° F)], check the transmission fluid level by referring
to the left diagram.
13.When the transmission fluid is less than the specified level,
add transmission fluid.
When the transmission fluid is greater than the specified
level, drain the excess fluid through the drain plug to adjust
the transmission fluid to the specified level.
14.Firmly insert the dipstick into the oil filler tube.