Specifications

MAINTENANCE SERVICE
TSB Revision
GENERAL
00-50
14. TRANSFER OIL
M1001003000178
Checking transfer oil level
1. Remove the filler plug.
AC102278
AK
FILLER PLUG
TRANSFER
OIL
FILLER PLUG
HOLE
2. Check that the oil level is up to the lower edge of the filler
plug hole.
3. Check that the oil is not noticeably dirty.
4. Tighten the filler plug to the specified torque.
Tightening torque: 32 ± 2 N⋅ m (24 ± 1 ft-lb)
Change transfer oil
AC101739
AC
FILLER PLUG
DRAIN PLUG
CROSS-
MEMBER
1. Remove the drain plug and discharge the oil.
2. Tighten the drain plug to the specified torque.
Tightening torque: 32 ± 2 N⋅ m (24 ± 1 ft-lb)
CAUTION
Cover the heat protector of the front exhaust pipe with
cardboard or something similar when refilling transfer oil
so that transfer oil dose not enter the area between the
front exhaust pipe and heat protector.
3. Fill oil to the bottom of the filler plug hole.
Specified oil: Hypoid gear oil API classification GL−5
SAE90
Quantity: 0.53 dm
3
(0.56 quart)
4. Tighten the filler plug to the specified torque.
Tightening torque: 32 ± 2 N⋅ m (24 ± 1 ft-lb)
15. ENGINE COOLANT (CHANGE)
M1001003100465
Check the cooling system parts such as the radiator, heater
and oil cooler hoses, thermostat and their connections for leak
-
age and damage.
Chang Coolant
WARNING
When removing the radiator cap, use care to avoid
contact with hot coolant or steam. Place a shop towel
over the cap and turn the cap counterclockwise a lit
-
tle to let the pressure escape through the vinyl tube.
After relieving the steam pressure, remove the cap by
slowly turning it counterclockwise.
1. Drain the water from the radiator, heater core and engine
after unplugging the radiator drain plug and removing the
radiator cap.