Specifications

MAINTENANCE SERVICE
TSB Revision
GENERAL
00-52
16. COOLANT HOSES (RADIATOR HOSE,
HEATER HOSE) (INSPECT)
M1001009700108
Inspect the surface of radiator hoses and heater hoses for heat
and mechanical damage. Hard and brittle rubber, cracking,
tears, cuts, abrasions and excessive swelling indicate deterio
-
ration of the rubber.
17. DISC BRAKE PADS (INSPECT FOR WEAR)
M1001003200365
ACX00898
AB
Check for fluid contamination and wear. Replace the complete
set of pads if any one pad is defective.
Thickness of lining
Minimum limit: 2.0 mm (0.08 inch)
CAUTION
The pads for the right and left wheels should be replaced
at the same time. Never split or intermix brake pad sets. All
four pads must be replaced as a complete set.
18. BRAKE HOSES (CHECK FOR
DETERIORATION OR LEAKS)
M1001003400411
Inspection of brake hoses should be included in all brake ser-
vice operations.
The hoses should be checked for:
AC201038
AB
BRAKE HOSE
1. Incorrect length, severe surface cracking, pulling, scuffing or
worn spots. (If the fabric casing of the hoses is exposed by
cracks or abrasion in the rubber hose cover, the hoses
should be replaced. Eventual deterioration of the hose and
possible bursting failure may occur).
2. Incorrect installation, twisting or interference with wheel, tire
or chassis.
19. BALL JOINT AND STEERING LINKAGE
SEALS (INSPECT FOR GREASE LEAKS AND
DAMAGE)
M1001003500429
AC100948
BOOT
DUST
COVER
AB
1. These components, which are permanently lubricated at the
factory, do not require periodic lubrication. Damaged seals
and boots should be replaced to prevent leakage or grease
contamination.
2. Inspect the dust cover and boots for proper sealing, leakage
and damage, and replace them if defective.