Manual

Appendix C: Remote Control Programming Codes,
continued
IMPORTANT
Some manufacturers may change their
products, or they may use more than one
remote control system. If this is the case,
your remote control may not be able to
operate your VCR, DVD, cable box, satellite
receiver, or A/V receiver.
After entering the correct codes in each position of
the remote control, use the slide switch to select
which product will respond when an operational
button is pressed. Only one of the below devices is
allowed for each slide switch position.
TV position:
[] TV, NetCommand® Controlled Devices
Cable/DBS/DTV position:
[] Cable box
[] Satellite receiver
[] DTV receiver
VCR position:
[] VCR
DVD position:
[] UVU
[] LD Player
Audio position:
[] A/V receiver
[] Mitsubishi CD player
If you have a Mitsubishi A/V receiver, the audio
position may be used in conjunction with select
Mitsubishi CD players. Your audio position must be
programmed to 010.
When your remote control has been programmed to
operate another manufacturer's product, the function
performed on each layer can vary. The most common
functions are:
VOR
• POWER
• CHANNEL up/down
• PLAY
• REC
• PAUSE
• STOP
• FF/FWD
• REW/REV
Mitsubishi VCRs will be compatible with some
additional buttons
Cable Boxes and Satellite Receivers
• POWER
• CHANNEL up/down
• 0-9 number buttons (on some models)
• ENTER (on some models)
• CANCEL (on some models)
• ADJUST up/down/left/right (on some models)
• GUIDE (on some models)
A/V Receivers
• POWER
• VOLUME
• MUTE
Mitsubishi A/V Receivers
• Direct Input Selection buttons:
numbers, SQV and QV (on some models)
Mitsubishi CD Players
not all functions for all models)
• PLAY
• FF/FWD
• REW/REV
• PAUSE
• STOP
DVD and Laser Disc Players
not all functions for all models)
• POWER
• MENU
• 0-9 number buttons (on some models)
• PLAY
• STOP
• ARROW up/down/left/right (on some models)
• FF/FWD
• REW/REV
• PAUSE
• CANCEL (on some models)
• ENTER
• CHANNEL (on some models)
89