Specifications

IMPORTANT

For further assistance, call

(800) 332-2119.

Appendix G: Diamond Shield™ Removal

The Diamond Shield is installed by the factory to

enhance your television viewing experience. If you

want to remove the Diamond Shield, please follow

the steps listed below:

To Remove the Diamond Shield:

1. While wearing soft cotton gloves, loosen the

sides of the Diamond Shield by pressing a small

plastic card (the size of a standard credit card or a

clean, plastic, putty knife) into the middle of the

side slot. The Diamond Shield side will snap out

of the top middle and bottom clips. Loosen both

sides before proceeding to step 2.

2. After the sides are free, gently push down on the

top of the Diamond Shield. It will slide out of the

top channel.

3 Carefully pull the screen up to remove it from the

bottom channel. Store the Diamond Shield in a clean,

dust free area, where it will not be scratched.

To Install the Diamond Shield:

4. Slide the Diamond Shield into the bottom channel,

making sure it fits securely.

5. Press gently on the top of the Diamond Shield to

slightly bow the screen towards you. Insert the

top of the Diamond Shield into the top channel. It

should fit securely.

6. At each side, gently press the top, middle and

bottom of the Diamond Shield to snap it back into

place.

WARNING

Sharp edges! Always wear gloves to

handle, lift, install and remove the

Diamond Shield.