Manual

: Use of the Remote Control with Other A/V Products
_To Program the Remote to Control
Other Brands of Audio and Video
Products-
(Figures 1-5)
_11 Move the slide switch at the top of the
remote to the product you want to control.
[] Press and hold the POWER button on the
remote control.
[]
[]
Enter the first three digit code listed for your
equipment, and then release the POWER
button on the remote control.
Point the remote control to the equipment
and press the POWER button.
Note: If the equipment responds, the remote
control is properly programmed to operate
the equipment. If the equipment does not
respond, repeat steps 2-4 with the next
three digit code listed in step 3 for your
equipment.
D
TV
POWER
m
Satellite brand Codeto enter: If your
Mitsubishi DTV- DBS 006 satellite
DishnetworkiEchostar 175 receiver
Hughes - DBS 173 code is not
RCA- DBS 176 listed here,
please see
Sony - DBS 177 page 68
Toshiba - DBS 170 for a
Panasonic - DBS 174 complete
TO reset to default code, enter 000 listing.
Figure 2. Programming the remote to control your
satellite receiver.
El
TV
POWER
£
[_,3FJ_FJ:_I
_1_][_
Cable box brand
General Instruments/
Jerrold
Oak
Pioneer
Scientific Atlanta
Zenith
Codetoen_r:
111,119,120,121,122,
123,124,125,126,127
102,137,139
101,116
111,112,113
100,117
To reset to default code, enter 000
Ifyour
cable box
code is not
listed here,
please see
page 68
for a
complete
listing.
Figure 1. Programming the remote to control your cable
box.
D
m
TV
POWER
VCR brand
Mitsubishi
Hitachi
JVC
Phillips / Magnavox
Panasonic
RCA
Sony
Toshiba
C0det0en_r:
001,002
020,043,065
030,054,059
043,044,051
041,042,043
020,053,065,079
048,049,050,074,075
021,
To reset to default code, enter 000
Ifyour
VCR
code is not
listed here,
please see
page 68
for a
complete
listing.
Figure 3. Programming the remote to control your VCR.
iMPORTANT
|MPQRTANT