Manual

Part II1: Setup
Use of the Remote Control with Other A/V Products
D
TV AUDIO
POWER
DVD/LDP brand Codetoenter: if you r
Mitsubishi (DVD) 003 DVD
Mitsubishi (LDP) 016, 017 code is not
Panasonic 250 listed here,
Pioneer DVD (LDP) 252 (016, 017) please see
page 68
Sony 254 for a
Toshiba 253 complete
Zenith 259 listing.
TO reset to default code, enter 000
Figure 4. Programming the remote to control your DVD/
LDP.
TV
il
£
POWER
Audio brand Codetoenter:
MitsubishiAN receiver _ your
audio
and/orCD player 010, 011 code is not
Kenwood 200, 208 listed here,
Onkyo 209, 214,240 please see
Pioneer 205, 207 page 68
Sony 222 for a
Yamaha 201,202 complete
Harman 215 listing
Teac 210
Figure 5.
receiver.
To resetto defaultcode,enter000
Programming the remote to control your A/V
| PQRTANT
|MPQRTANT
After entering the correct codes in each
position of the remote control, use the slide
switch to select which product will respond
when an operational button is pressed. If you
enter a code from the AUDIO chart while the
slide switch is set to TV, the volume and mute
functions change to match the AiV receiver.
This is useful when using an AiV receiver with
the TV all the time. In all other cases, only
one of the below devices is allowed for each
slide switch position.
TV position:
[] TV
AiV receiver (volume and mute only)
CableiDBSiDTV position:
EmJCable box
E_J Satellite receiver
E_J DTV receiver
VCR position"
VCR
DVD position"
E_J DVD
E_J LD Player
Audio position:
AiV receiver
Mitsubishi CD player
If you have a Mitsubishi AiV receiver, the
audio position may be used in conjunction
with select Mitsubishi CD players. Your audio
position must be programmed to either 010
or 011. Plug the CD player power cord into
a switched outlet on the back of your AiV
receiver. Pressing the POWER button turns
On the AiV receiver, along with the CD player.
In the audio position, for some CD players,
the transport controls (FF, Play, Rew, etc.)
operate the CD player.