Manual

Appendix E: Diamond Shield Installation and Removal
Diamond Shield TM Installation and Removal Procedure
(VS-50111, VS-60111, WS-55311, WS-55411, WS-65311, WS-65411, WS-73411)
Follow the steps below to install and remove the
Diamond Shield TM
INSTALLATION
Note: Included in the Diamond Shield TM
package are the following items:
[] (1) Diamond Shield TM
[] (2) Molding Clips
[] Carefully remove the Diamond Shield TM from its
protective packaging. Wipe off any dust with a lint-free
cloth.
[] Begin by inserting the shield, sliding it into the
channels, starting at one side. Gently bow the
Diamond Shield TM toward you and insert the other side
of the Diamond Shield TM into the oppositive channel.
Install the top and bottom molding clips by pressing
them into the opening starting at a corner. Do not
force the clip. The clip will slide into place. This
completes the Diamond Shield TM installation.
REMOVAL
To remove the Diamond Shield TM,
reverse the order of the above procedure.